Ledson Pollux9+ Gen 2 LED Spot

Ledson Pollux9+ Gen 2 LED Spot

We listened to you and developed an exclusive product that has never been on the market before!

LEDSON Pollux 9+ is equipped with a selectable yellow-orange or xenon white position light. Furthermore, Pollux9+ is available in two different versions; with Driving Beam (art. no. 33491211) and Spot Beam (art. no. 33491212) light image. Spot Beam provides up to 120 meters longer visibility compared to Driving Beam, while Driving Beam provides a greater width of light. Both variants of Pollux9+ have an E marking and are equipped with TIR reflectors for minimal light waste.

TIR reflectors
TIR stands for Total Inner Reflection and means that all light is effectively reflected and focused before being sent away from the reflector. The stray light (the light that is not focused but disappears "unfocused" from the lighting without really doing anything good) is minimized. A traditional reflector directs and focuses most of the light, but far from it all, Pollux 9+ has these TIR reflectors for maximum light.

In summary: you get more efficient light on the road and get the most out of every LED on the extra light with the TIR reflectors!

Characteristics:
E-marked (E8, ref. 37.5 for Driving Beam, ref. 50 for Spot Beam), ECE R112 / R10 / R7 (white position light)
EMC-fused (does not interfere with the radio)
With position light (4 pieces LED) yellow-orange or xenon white (switch the desired color)
Spot Beam Range: 1090 m (0.25 lux), 545 m (1 lux)
12000 lumens (theoretical), 9600 lumens (actual)
Cold white light (6500 K)
TIR optical system (Total Inner Reflection)
Pressure equalization membrane
24 months warranty

Technical data:
120W (12 x 10W Cree XM-L2 LED)
Rated power 92.4 W.
IP68 (waterproof/dustproof)
Includes DT connector (4-pin)
Electronic heat management
Voltage 9-36 V
Charge 7.7 A at 12 V and 3.6 A at 24 V

Dimensions and weight:
Width: 218mm
Height: 234.5 mm (incl. bracket)
Depth: 68.5mm
Weight: 1.9kg

Included:
Pollux9 + LEDSON LED extra light
Bolts and screws for attaching the additional lighting with one or two mounting points
DT connector (4 pin) complete with DT relay wiring
Installation instructions

Cable installation instructions (detailed installation instructions are included with the product):
Red: Extra light (+)
Black: Extra light / position light (- ground)
White: position light (+) white light
Yellow: position light (+) yellow-orange light
NOTE: The DT connector should not be cut as this increases the risk of moisture damage and will void the warranty.